Page 7 - Manual – Gas patio heater G21 – Inferno

• Pilot flame can be watched and checked from the small round window with sliding lid located
at the bottom of the flame screen (to the left or right side of the controller).
• If the pilot flame does not light or it goes out, repeat step 3 (a 5 minute complete shut off
period is necessary before relighting).

To turn off the appliance:
• Turn the control knob to PILOT position
• Push and turn the control knob to OFF position.
• Turn the regulator connected to the gas cylinder to OFF position.

Cleaning and care
• Wipe off powder coated surfaces with soft, moist rag. Do not clean the appliance with cleaners
that are combustible or corrosive.
• Remove debris from the burner to keep it clean and safe for the next use.
Construction and characteristics
• Transportable terrace/garden heater with tank housing
• Casing in steel with powder-coating or stainless steel
• Gas connections equipped with metal clamp
• Heat emission from reflector
Specifications
• Use propane/butane or their mixture gas tanks only
• For outdoor use only

Troubleshooting
Service and maintaining
Periodic maintenance should be performed at intervals not exceeding 6 months or when
obvious fault occurs, i.e. flame burning abnormality or burner discoloration. These are general
signs of gas supply blockage or blocked burner ports.
To clean the burner ports, remove the reflector assembly by removing three nuts at the top
of the reflector. The mesh screen may then be extracted by removing four retention screws
at the base of the mesh screen and four screws at the top of the screen. Remove two screws
retaining the burner assembly, rotate the burner assembly slightly then remove the burner
assembly upwards.
Care should be always taken to avoid damage to the gas piping and ignition lead. The burner
and mesh screen may then be clean by compressed air. Assembly is a reversal of the above
steps.