Page 5 - Manual – Gas patio heater G21 – Inferno

all connections have been leak tested.
9. Turn off the gas valve immediately if smell of gas is detected. Turn Cylinder Valve OFF. If leak
is at Hose/Regulator connection: tighten connection and perform another leak test. If bubbles
continue appearing should be returned to hose’s place of purchase. If leak is at Regulator/
Cylinder Valve connection: disconnect, reconnect, and perform another leak check. If you
continue to see bubbles after several attempts, cylinder valve is defective and should be
returned to cylinder’s place of purchase.
10. Do not transport heater while it’s operating.
11. Do not move the heater after it has been turned off until the temperature has cooled down.
12. Keep the ventilating holes empty and debris-free.
13. Do not paint the radiant screen, control panel or top canopy reflector.
14. Control compartment, burner and circulation air passageways of the heater must be kept
clean.
15. Frequent cleaning may be required as necessary.
16. The LP tank should be turned off when the heater is not in use.
17. Check the heater immediately if any of the following occurs:
• The heater does not reach temperature.
• The burner makes popping noise during use (a slight noise is normal when the burner is
extinguished).
• Smell of gas in conjunction with extreme yellow tipping of the burner flames.
18. The LP regulator/hose assembly must be located out of pathways where people may trip over
it or in area where the hose will not be subject to accidental damage.
19. Any guard or other protective device removed for servicing the heater must be replaced
before operating the heater.
20. Adults and children should stay away from high temperature surface to avoid burns or clothing
ignition.
21. Children should be carefully supervised when they are in the area of the heater.
22. Clothing or other flammable materials should not be hung on the heater or placed on or near
the heater.
23. If you want to change the gas hose, keep in mind it needs to be 60 cm long.
24. Use 10 kg gas cylinders with safety valve for this appliance only.
25. To change the gas cylinder in a amply ventilated area, away from any ignition source (candle,
cigarettes, other flame producing appliances).
26. Check if the regulator is secured firmly as shown in the picture.
27. Keep the ventilating holes always open.
28. Close the gas supply each time after you turn the appliance off.
29. In the event of gas leakage, the appliance shall not be used or if alight, the gas supply shall be
shut off and the appliance shall be investigated and rectified before it is used again.
30. Check the hose at least once per month, each time the cylinder is changed or each time
before long time no use. If it shows signs of cracking, splitting or other deterioration it shall be
exchanged for new hose of the same length and of the equivalent quality.