Page 10 - Manual - Food processor G21 Vitality - Promesso
P. 10

Meat Mincer
        Initial Operation - General
        1.  Remove the cover (2a) from the helix drive and take out the screw.
        2.  Place the screw housing (10) with the filler neck facing upwards into the screw drive and turn
        the screw clockwise until it is closed.
        3.  Place the filling tray on the filler neck in such a way that the receptacle of the tray is positioned
        under the arm.
        4.  Push the screw into the horizontal section of the screw housing until the axle locks in place.
        Please see the sections on “Operating the Mincer” and “Sausage Attachment”.
















        Operation Meat Mincer (see illustration A)
                                          A


                              10        11       12     13       14









        1.  First place the blade on the end of the screw and then a screen of your choice. Please pay
        attention to the screen and the recesses on the helix housing. Screw the nut (14) on until it is “hand
        tight”.
        2.  Put the pieces of meat on to the filling tray (17) and into the filler neck.
        3.  Place a vessel under the exit.
        4.  Please ensure that the function switch (6) is turned to “Off”.
        5.  Connect the device to a 230 V, 50 Hz safety contact power socket.
        6.  Turn the mincer on with the switch (6).
        7.  If necessary push the meat with the tamper (18). Please do not follow this up with your fingers.
        NOTE:
        •  Cut the meat into pieces of about 2.5 cm. Please take care that the meat does not contain any
        bones or sinews.
   5   6   7   8   9   10   11   12   13   14   15