Page 7 - Manual – Blender G21 – Ultimate

Tip: If you want to vacuum pump only, press , then Start/Stop button.
After vacuuming and blending are fi nished, please lift the vacuum outlet (silicon) on the Lid for
releasing the air pressure, ONLY then you can open the Lid on the Mixing jar.
Do it yourself – set your own programs (DIY)
1. Smart constant speed mode
In standby mode, press on “Set” button, it goes into Constant speed mode. Press +- buttons
of Time and Speed to adjust the working time and speed.
Press to start blending. Appliance will work at your set mixing speed and time until fi nish
automatically. During the blending process, you can always adjust your settings.
Default initial mixing time is 3 minutes, mixing speed 0.1.2.3…H are available for choice.

2. Smart DIY mode
You can set your own programs to get customized creations
2.1. In standby mode, press both “Set” and one of the program buttons you want to adjust
(Smoothie, Milkshake, Whole juice, Crush ice, Nut milk, Grind) until you hear a beep. Then
press Time and Speed +- buttons to adjust the mixing time and speed. Press OK button to
save your settings. It goes automatically to setting for next step.
2.2. You can repeat the previous process up to 10 times for one program.
2.3. After fi nishing all the settings, shortly press “Set” button. The appliance saves all the
steps you set and quit DIY mode. It will work at these set workings steps always, until you
re-set the program again.
2.4. For instance, let’s say you want to set below programs:
STEP 01 STEP 02 STEP 03 STEP 04 STEP 05 STEP 06-10
A Speed 1/10S Speed 2/3S Speed 5/5S 0 0 0
B Speed 1/15S. Speed 2/3S Speed 1/14S Speed 2/3S Speed 7/3S 0
C Speed 3/10S Speed H/165S 0 0 0 0
2.5. Program A
In standby mode, press and hold buttons “Set” and program A at the same time, until you
hear a beep. Step 01: press the + button on the right side of control panel and choose speed
1. Then press + button on the left side of control panel and choose 10 seconds. Press the OK
button to move to step 02. Choose speed 2 for 3 seconds, press OK and move to step 03.
Choose speed 5 for 5 seconds, press OK button and move to step 04. Choose speed 0 for
0 second, shortly press the “Set” button to save the settings. Press program A button – the
display will show “Sec: 018” which means you set the program successfully.
2.6. Program B
In standby mode, press and hold buttons “Set” and program B at the same time, until you
hear a beep. Step 01: press the + button on the right side of control panel and choose speed
1. Then press + button on the left side of control panel and choose 15 seconds. Press the OK
button to move to step 02. Choose speed 2 for 3 seconds, press OK and move to step 03.
Choose speed 1 for 14 seconds, press OK button and move to step 04. Choose speed 2 for
3 seconds press Ok and move to step 05. Choose speed 7 for 3 seconds press OK and move
to step 06. Choose speed 0 for 0 second, shortly press the “Set” button to save the settings.