Page 5 - Manual – Blender G21 – Perfection

Warning
1. Make sure that the appliance has not been damaged during transport.
2. Make sure you have all parts of the appliance.
• 1x Instruction Manual
• 1x Blender
• Big lid, small lid, tamper, main body, jar (including blade and the retaining nut), spanner, spatula.
3. Place the appliance on a level stable surface. Do not tilt the appliance. Do not place the appli-
ance near flammable materials.
4. Protect the appliance against direct sunlight and rain.
5. In order to prevent leakage of electricity, the appliance must be plugged into a properly groun-
ded electrical socket.

Safety instructions
1. Before first use read the safety instructions.
2. Make sure the appliance is plugged in 220-240 V socket.
3. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
4. DO NOT allow children to play with the appliance. Keep them at a safe distance from the
appliance while operating.
5. Do not forget to install the lid for container before using. Thanks to Big lid’s opening and pusher
is possible to mix the ingredients inside the device. After the device is turned off, remove the con-
tainer and use the spatula to remove all food residues.
6. When switching on the appliance, hold the lid to prevent its release.
7. During operation, do not remove the lid and do not put your hands into the jar.
8. Do not put any metal items like knives, forks, spoons, etc. into the JAR.
9. Do not leave the appliance run on empty. It causes generation of high temperatures that may
cause damage to the lubrication system of the appliance.
10. In case that blade drops out or breaks, immediately switch off the appliance. Then contact the
authorized service center.
11. During cleaning or removing parts, do not forget to turn off power and unplug the appliance.
12. Do not immerse the main body into water. Do not wash the main body under running water
directly in order to prevent electric shock.
13. Do not clean the blades with bare hands because they are very sharp. Use brush or a strong cloth.
14. If the appliance does not work, pull it from the wall socket and wait until the temperature fall.
15. If the power cord is damaged, the replacement must always be carried by an authorized servi-
ce center.
16. One mixing cycle should not exceed 5 minutes. When mixing dense mixtures, the mixing time
should not exceed approximately 2 minutes. A break must be taken between individual mixing
cycles to allow the blade bearing to cool down to prevent damage to the blades or container.
17. You have purchased a new product that has not yet been used. During the first working cycles,
the surface finish of the new engine carbons wears out. This process creates an odor that di-
sappears after the finish wears off. This fact is completely normal and is not a defect.