Page 6 - Manual – Countertop Reverse Osmosis System G21 – Osmo Pro

First use
1. Place the appliance on a flat surface, such as a table or kitchen counter.
2. Remove the water tank and fill it with fresh tap water. Replace the water tank and close the lid.
3. Plug the appliance into the mains. Long press the Power button for 2 seconds to start the
appliance.
4. To achieve excellent water quality, it is recommended to clean the appliance with the “Wash”
program. Place a container (large cup or small bucket) under the outlet and press the “Wash”
button for 3 seconds. The cleaning process will take approximately 6 minutes. After the
cleaning process is complete, empty the water tank and refill with fresh water. The appliance
will start filtering the water automatically. Once the filtration is complete, you can fill the water.
Daily use
1. Press the button of the selected temperature program.
2. Press the button to fill the water. Press it again to stop filling. .

Using the Coffee, Tea and Hot programs
1. Press the Lock button to unlock high temperature programs.
2. Press the button of the selected high temperature program.
3. Press the button to fill the water. Press again to stop filling.

Small Cup, Big Cup
1. Press the button of the selected volume output.
2. Press the button of the selected temperature program.
3. Press the button to fill the water.

Note:
Water filling will stop automatically when the volume exceeds 1000 ml.
Be careful not to get scalded when filling with hot water.To prevent scalding, drain some water
using the “Normal” program after using a high temperature program
Manual temperature setting for the Hot program
Long press the “Hot” program for 3 seconds - the device switches to temperature control mode,
the display shows “95”. Press the “Small cup” button to decrease the temperature by 1 degree and
the “Big cup” button to increase it by 1 degree. The lowest possible temperature that can be set
for this program is 85 °C. The desired temperature setting is saved automatically after 5 seconds
of inactivit.

Cooling function
When using the cold water program for the first time, press the “Cold” button and then the
button to release air from the internal tubes until water starts to flow out. Then stop the water
dispensing.
If the water level in the water tank with the transparent window is still low, you can press the
“Normal” program and drain the water for about 10 seconds. Once the water level rises, the water
draining can be stopped. To turn on the cooling function, long press the “Cold” temperature button
for 5 seconds. To turn it off, press the “Cold” button again for 5 seconds.