Page 7 - Manual – Gas patio heater G21 – Moon

3. Press down the variable control knob and hold for 90 seconds. While holding down the
variable control knob, press the ignition button several times until the pilot flame lights up.
Release the variable control knob after the pilot flame lights.
• If a new tank has just been connected, allow the air in the gas pipeline to purge through the
pilot hole at least for one minute.
• When lighting the pilot flame, make sure the variable knob is continuously pressed down
while pressing the ignition button.
• Pilot flame can be watched and checked from the small round window with sliding lid
located at the bottom of the flame screen (to the left or right side of the controller).
• If pilot flame does not light up or it goes out, repeat step 3.
4. After the pilot flame lights up, turn the variable knob to maximum position and leave it there
for 5 minutes or more before turning the knob to desired temperature position.

To turn off the heater: OFF
1. Turn the variable knob to PILOT position. PILOT
2. Press and turn the variable knob to OFF
position.
3. Turn off the valve on the gas supply LO HI
cylinder completely.
Storage
1. Always close the gas valve of the gas
cylinder after each use or in case of IGNITER
disturbance.
2. Remove the pressure controller and the
hose.
3. Check the tightness of the gas valve and possible damage. If you suspect any damage,
have it changed by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain or at places without adequate air ventilation.
Cleaning and care
• Wipe off powder coated surfaces with soft, moist rag. Do not clean the heater with cleaners
that are combustible or corrosive-
• Remove debris from the burner to keep it clean and safe for use.