Page 4 - Manual – Construction frame G21 – for garden swing

3. Check the dimension showed on the diagram and correct if necessary.
4. Under the four feet, mark a square of 35*35 cm and dig a 35 cm deep hole.
5. Fill these holes with concrete following the diagram of the recto. The top of the concrete should
not exceed ground level.
6. Place the sealing legs in the concrete in the located place (see point 2). Make sure the drilled
end of the sealing legs is above the level of the concrete.
7. Once the concrete is set, screw the feet into the sealing legs.
8. Ensure that the concrete is completely dry before using the swing.
9. Cover the concrete with soil.
We strongly advise checking the anchoring periodically.
MAINTENANCE
All metal parts are galvanized steel and powder coated for rust protection. However, in certain
areas close to the sea we advise that additional rust prevention treatment may be necessary.
• The surfaces of all the parts should be checked at least once a month, escpecially for the fixtu-
res such as hooks on the overhead beam. If the fixtures and hooks show wear over 10 % of their
original thickness, then they should be replaced with the same fixtures as those originally provided.
• All parts that are under constant friction should be oiled regularly with a suitable lubricant.
• The ground on which the product is placed should be controlled regurarly. All elements such as
stones or other objects that could cause injury in the case of a fall should be removed.
• It is advised to remove the apparatus during the winter period, when not in use, to avoid any
deterioration due to bad weather conditions.
• Check for signs of wear, especially where swinging apparatus’ plastic ring attached to the me-
tal swing hooks on the upper beam. As soon as the plastic ring shows signs of deterioration, the
apparatus should be replaced.
All used apparatuses and/or parts must be replaced by a part delivered by our G21 authorized
service center.
If the swing set develops a squeak, apply a suitable gel lubricant. Do not use liquid lubricant as it
will run down the fixings and apparatus. The height of the swing can be adjusted using the plastic
eyelet fixture. By pulling the rope through the fixture, the height of the seat can be adjusted to suit
the user.

SAFETY
Safety checks should be carried out regularly on this product. These checks should include, if
necessary, removing any sharp edges, replacing missing screw covers and tightening the nuts
and bolts. These checks should be done to avoid any danger or upturning of the swing set through
normal wear and tear.
The dimensions given and indicative only, they may vary according to the assembly method.
This swing set must be used under adult supervision.
CAUTION! Fall danger