Page 7 - Manual Sous Vide Akura

Troubleshooting
Grinding noise
The stainless steel skirt is loose. Push it up into the guide groove and turn to the left until you hear
a click. WIth the skirt secured, the noise will go away. There also might be a chance the stirring
shaft was bent. In that case, unscrew the bottom pump disk and gently push the impeller till it is
centered.
Slurping noise
The pump has formed a water vortex like when you empty out a sink or bath tub. Add more water
or gently disturb the water with a spoon. There is no sure way to eliminate the vortex from forming
due to the pump rotation, but it will usually go away on its own.
Gurgling and woosh noise
The pump is sucking air and you should also see small bubbles in your tank – add more water.
The system will not turn on
Check the power plug and breakers.
Low water level alarm
The water level may drop during operation by the pump due to water turbulence – add more water.
If the alarm turns on after a few seconds of operating, add more water. Sometimes the waves will
cause the water level at the sensors to fluctuate up and down.
Error code EE1 will appear in following situations:
• no water in tank
• water below minimal level

Technical specification:
Power rate: 220-240V, 50Hz, 1000W
Temperature range: 0°C-90°C
Temperature stability: ± 0,1°C
Ciculation pump: 12 LMP max

The English version of the manual is an exact translation of the original manufacturer‘s instructions.
Images used in this manual are for illustrational purposes only and may differ from the actual product.