Page 5 - Manual – Countertop Reverse Osmosis System G21 – Osmo

TDS value display
The device display shows the TDS value - the amount of dissolved substances in the water (Total
Dissolved Solids). This data is measured at the output of the second reverse osmosis (RO) filter
and serves as an approximate monitoring of the filtration efficiency.
It is important to know that:
This is not the final value of the water at the output, but the value measured during the filtration
process.
The TDS value may increase slightly over time, which is completely normal.
Each location has different input TDS values - it depends primarily on the composition and
hardness of the water in the area.
An increase in the TDS value over time can also be a signal to replace the filter cartridges, but it
depends on the intensity of use and the quality of the input water
First use
1. Place the appliance on a level spot - due to the frequent refilling of
water, it is advisable to place the appliance, for example, on the
kitchen counter near the water tap.
2. Remove the water tank, fill the tap water section up to the MAX mark
and return the water tank to its intended location.
3. Plug the power cord into a power outlet.
4. The appliance automatically flushes the entire filter system and pipes.
This process takes approximately two minutes. When finished, pour
the water out of the tank and refill it with clean water.
5. The device will automatically start the filtration process. After filtration is
complete (indicator No. 1 on the left of the display stops flashing),
start rinsing the device using the “Wash” program. Press and hold
this button for 3 seconds. The device will drain the tank with filtered water, then end the
program by pressing the button again. To achieve excellent water quality, we recommend
repeating the “Wash” program two more times.
6. After rinsing the device using the “Wash” program, pour clean water into the tank. After filtering,
the water can be consumed. After filtering, refill the tank to extend the life of the filters.
7. When using for the first time, do not select a high-temperature program to prevent damage to the
internal electronics. First, select a program with room temperature, for example, and then a
high-temperature program.
Daily use
This purifier offers 6 temperature modes. The „Honey“, „Milk“ and „Normal“ modes automatically
start pouring water. To select the other three high temperature programs, you must first press and
hold the lock button.
Water pouring can be interrupted by pressing any temperature button.
Note: If you select a lower temperature after pouring the hot water, it is normal for the remaining
hot water from the previous process to flow out first.