Page 3 - Manual – Digital safe G21

EN

Thank you for purchasing our product.
Before using this unit, please read this manual in order to avoid improper handling and use
of the device.
You have just made an important step to protect your property. Each of our safes is professionally
produced and ensures the greatest possible security. Before using read carefully the instructions
on the following pages of this manual.
! PLEASE KEEP THE KEY IN A SAFE PLACE

First use
Method one:
• Find the accessories bag in the package and take out the emergency keys.
• Remove the battery cover, the key hole is on the right side of the battery box.
• Insert the emergency key into the key hole, rotate the key anti-clockwise and the knob clockwise
to open the door.

Method two:
• Find the accessories bag in the package, take out four AAA batteries and put them in the battery
box.
• The safe should have electricity now, input preset user code “159” to open the door. Every time
you press the number, yellow light will flash once with one beep. If the code is correct, green light
flashes for 6 seconds with two beeps.
• Rotate the knob clockwise and open the door within 6 seconds of entering the code.
WARNING: take care about the right polarity of inserted batteries. If there is a failure of the voltage
supply longer than 3 minutes, the safe will be reset and it is necessary to proceed according to
“First use” chapter.
Set the user code
Find the green reset button on the back of the safe door. Press it, yellow light will flash twice with
two beeps.
Enter new user code with 3-8 digits immediately and press “#” to confirm.
If set successfully, yellow light will flash twice with two beeps.

Set the master code
With the door unlocked, input “00” and press the reset button. Start setting the master code when
yellow light goes on.
Input new master code with 3-8 digits and press “#” to confirm. The code is set successfully when
yellow light flashes twice with two beeps.
If the light flashes with three beeps, the code change was not effective and you need to try again.
Open the door
1. Enter the 3-8 digit user code and press “#”. If it is correct, green light will flash for 6 seconds
with two beeps. Turn the knob clockwise to open the door.
2. Enter the preset password “159” and press “#”. If it is correct, green light will flash for 6 seconds
with two beeps. Turn the knob clockwise to open the door.
CAUTION: Entering wrong code leads to yellow light flashing three times with three beeps.