Page 6 - Manual – Dehumidifier G21 – Impact 16
P. 6

Operation
          Timing off
          When the dehumidifier is running, press this button to adjust the time between 0 hour and 24
          hours, Press the button once to increase the set time by 1 hour. After the set time exceeds
          24 hours, the display returns to 0 to start the cycle again. When the set time is reached, the
          dehumidifier turns off automatically. After setting is completed, the set time is confirmed after 5
          seconds. In the ‘timer off’ state, the button light on the button is lit.

          Timing on
          When the dehumidifier is in the standby state, the method for adjusting the set time by the
          button is the same as for timer ‘off’. When setting is completed, the set time is confirmed after 5
          seconds. In the ‘time on’ state the light on the button is lit, and the set time is displayed on the
          control panel.

          AUTO mode
          Select AUTO dehumidification. If the room humidity is higher than the set humidity or is between
          + 5 % or – 5 % of the set humidity, the compressor will start and the fan will run at the set speed.
          If the room humidity is lower than the set humidity by – 5 %, then the compressor will stop but
          the fan will run at the set speed. The default set humidity value is 50 %.
          Cloth dry mode
          Select CONTINUOUS dehumidification. Regardless of the relative humidity in the room, the
          compressor starts, the fan runs at high speed by default, and the fan speed can be regulated via
          the fan speed button.

          Drying function
          Press the DRYING button to start the drying process. The appliance starts at HIGH air speed and
          releases air continuously for 30 minutes. The appliance turns to run at LOW air speed and lasts
          for 15 minutes.
          To stop, press the DRYING button again to cancel the process and recover to the prior running
          mode. Or, press the POWER button to stop the process and recover to standby mode.
          Water drainage
          1.  Manual
            •  When the water tank is full, the full water icon on LCD display flashes (the compressor, fan will
             stop running), the buzzer sounds 10 times to remind the user till the water is drained.
            •  Place both hands respectively at the side of the back cover side of the depression, gently
             remove the water tank and open the tank cover on the right side of the body, then pour the
             water from the gap between water tank and the cover.
            •  Close the tank cover and rotate the water tank handle down, then put the water tank gently
             back in to restart the appliance.
   1   2   3   4   5   6   7   8   9   10   11