Page 8 - Manual – Blender G21 – Experience

2.7. Program C
In standby mode, press and hold buttons “Set” and program C at the same time, until you
hear a beep. Step 01: press the + button on the right side of control panel and choose speed
3. Then press + button on the left side of control panel and choose 10 seconds. Press the
OK button to move to step 02. Choose speed H for 165 seconds, press OK and move to
step 03. Choose speed 0 for 0 second, shortly press the “Set” button to save the settings.
Press program C button – the display will show “Sec: 180” which means you set the program
successfully.
Tip: Listed data above are for instance, you can set the programs however you like.

3. Cancellation of Smart DIY programs
If you want to cancel your DIY settings (let’s say program A), press and hold both program A
and OK buttons for 3 seconds. It deletes what you have set and goes back to factory settings.

Counting of mixing jobs and reset
When you plug in the appliance and press On button, the display screen will show the record of
total mixing jobs the appliance has served.
To reset, press both “Set” and buttons for 3 seconds.
To reset, press both “Set” and buttons for 3 seconds.

Technical parameters:
Voltage: 220-240 V
Frequency: 50/60 Hz
Wattage: 1500 W
Jar capacity: 1,2L
Temperature resistance of the jar: -20 °C to 90 °C
Lowest speed: 12000 RPM
Max speed: 28000 RPM