Page 6 - Manual – Blender G21 – Excellent

Step
Speed
Program
Time
Program
Time
Speed
Step
CLEAN
ICE
Nuts
Smoothie
Soup
Soy Milk
CLEAN
Program Speed Time Smoothie Nuts Soy Milk Soup ICE
Step
CLEAN
Control panel
ICE
LCD display
When plug in the device into power socket and turn on the device by pressing ON button, LCD
CLEAN
+ Smoothie Nuts Soy Milk display shows the speed no. 5 and time 20 sec and the device is in standby mode.
CLEAN
ICE
USER
START
ICE
Soup
STOP Control the device
ON/OFF
- SET + USER
Press the button ON/OFF to turn on the blender, the blender will switch into stand-
START
CLEAN
STOP
Program Speed Time Step by mode. Press the button ON/OFF again to turn off the blender.
ICE
Pulse
-
SET
Caution: The pulse function will be started at the highest speed. Make sure the
+ START Excellent USER container lid is mounted properly.
CLEAN
ICE Note: There is a 2 sec safety lag when using PULSE button during the program.
Smoothie Nuts Soy Milk
STOP Soup
Quick program
- SET Press the button SET when the device is in standby mode and no. 5 will fl ash
Excellent
on the display. Press the button + or – to set the desired speed in range 1 to 10
(highest). Press the button SET again to set the mixing time, which can be adjusted
CLEAN
ICE by pressing + or - button. The Quick Program will be switched on after the pressing
START button.
Excellent
User program
+ START USER Press the button USER when the device is in standby mode to switch to mode for
STOP manual (own) programmes.
There are 6 points A-F in the left column, you can save your own program under
- SET these points. Every program can save 6 steps, which are displayed under the num-
bers 1 – 6 in the right column.
After the transition to own program mode, the cursor is on the program A (the letter
A fl ashes).
If you press button + and – you can switch between individual programmes.
Excellent
You start programming of selected program when pressing button SET.
Step no. 1 will light up in the right part of the display. When pressing button SET
again you will be switched to speed setting and you can set the speed of step.no 1
1 – H (10) when pressing button + and -. When pressing the button SET again you
will be switched to time setting (min) and by pressing SET button again you will be
switched to seconds setting.
Press the SET button again to complete the setting of the step no. 1 and step no.2
will start fl ash. Next pressing of SET button will switch you to speed setting.
» » » » Speed » » Time » » Time » »
You can set up to 6 steps by using this procedure.
If you want to fi nish the programming, press USER button.
Deleting the program:
Individual step or program can be deleted by holding the SET button for 3 seconds.